Tel: (613)749-9585
Fax: (613)749-7614
5495 Canotek Rd.
Ottawa, ON
K1J 1H4



Hours of Operation

Monday - Friday 8am to 5pm
Saturday & Sunday - Closed
Find Our Location




Clematis Confusion

7) Clematis often blooms sparsely in the first year after planting. Plant some other annual free
blooming vines with it to fill in.

You don't HAVE to prune clematis. Pruning is only done if:

  1. The plants are out-growing their allotted space and
  2. The flowers are produced too high up to enjoy them.

Pruning in the latter case can even be avoided by retraining and tying shoots lower down on the support - say just above ground level. These shoots produce their flowers much lower down. Training shoots horizontally not only keeps the flowers within eye level, but provides better coverage of the support, and the reduced flow of sap encourages more flowers. Clematis can be roughly divided into three groups when it comes to the subject of pruning.

Group 1
Early-flowering species clematis (such as Clematis montana, C. macropetala and C. alpina) These plants flower on growth produced the previous year and, if needed, are just given a light pruning to remove spent flowers immediately after flowering.  Old, woody plants can be pruned very hard - down to a couple of feet if necessary, preferably to just above some strong, healthy growth - after flowering to remove lots of the old, non-flowering growth. Plants may take a year or so to fully recover and start flowering properly again.

Group 2
Large-flowered hybrids which start flowering in May/June. These varieties can be cut back fairly hard - say to between 90cm to 1.2m (3-4ft) high - to just above a fat pair of buds/single bud; the former is better. Start pruning at the top of the plant and work your way down.

Group 3
Large-flowered hybrids which start flowering in June/July, and C. texensis, C. tangutica and C. orientalis types. These can be cut back very hard - say to 23cm to 45cm (9-18in) high - again just above a pair of buds/single bud - removing nearly all of the previous year's growth. Start pruning at the bottom of the plant and work your way.

If you want to retain some tall growth on plants to retain cover of the supporting structure, you could cut down just half the shoots as described above. This will give slightly earlier but higher flowers on the un-pruned growth. The pruned shoots will flower a little later and produce flowers lower down the plant. This gives a better and slightly longer display.

After pruning
As with any plants, pruning should be followed by a good feed with a granular fertilizer. Rose food is excellent for this.


Landscape Installation